Heat transfer printing process should pay attention to what the problem?

Heat transfer printing process should pay attention to the following questions:

One, keep it clean:

1, to keep the machine working table, the guide roller, the parts clean clean, not stained with grease and dirt;

2, to keep the heat transfer film clean, not contaminated oil, fingerprint, dust etc.;

3, to keep the rubber head clean, no dirt adhered on the;

4, the hand of the operator should be kept clean, there can be no sweat, grease to prevent touch the flower membrane;

5, to maintain the burn clean, not stained with dirt, oil etc.;

Two, hot stamping temperature: hot stamping temperature in hot stamping equipment, hot printing film, hot stamping and different, not the blind pursuit of hot stamping temperature is high or (lower is better), should be in hot finishing effect as a benchmark to certain temperature hot stamping.

Three, hot stamping pressure: the hot stamping pressure must be adjusted to the most appropriate, or too easy to hurt the gum head and burn, too small and affecting the short-run effects. To adjust to the best stamping pressure shall be pressure regulating lock, so that changes in mass production.