Heat transfer printing is a new printing technology, imported from abroad more than 10 years. The process of printing mode is divided into transfer printing and transfer processing two parts, transfer film printing the printing pattern printed on the film surface, in advance, the printed patterns the level of rich, colourful, the myriads of changes, small color difference, good reproducibility, can reach the requirements of design effect, and is suitable for mass production; to do the heat transfer process, must have a high-quality heat press machine, the saying goes, "Good tools are prerequisite to the successful execution of a job. ", a good heat press machine, can make the job easier, therefore, get good heat transfer machine is very important, however good heat press machine maintenance is also very important, how to maintain? Please look at this:
1. pressure: if the pressure is not enough or too much, can adjust the pressure screw rod (located in the aluminum bottom), clockwise to increase pressure, counterclockwise to reduce pressure
2. time: when the transfer time to reach the buzzer does not ring or kept ringing, micro switch contacts shall check the tail box is moderate, if not suitable to be adjusted to the appropriate location.
3. the preheating temperature: about 15 minutes, when the temperature reaches the set temperature, the heating indicator light, can start the hot stamping; such as the boot minutes heating plate no fever, please check the line.
Do the above three kinds of maintenance details, heat press machine can keep the still fresh even after long in a certain extent, can heat transfer technology to make contribution!
System.String[]